NASA’s Lucy Spacecraft Hours Away from 1st Asteroid Encounter

We are only a few hours away from the NASA Lucy spacecraft’s first close up look at the small inner-main belt asteroid, Dinkinesh. Dinkinesh is 10 to 100 times smaller than the Jupiter Trojan asteroids that are the mission’s main targets. The Dinkinesh encounter serves as a first in-flight test of the spacecraft’s terminal tracking system.

Lucy’s closest approach will occur at 12:54 p.m. EDT (16:54 UTC) at a distance within 270 miles (430 km) of Dinkinesh. However, there won’t be much time to observe the asteroid at this distance as Lucy speeds past at 10,000 mph (4.5 km/s).

A graphic illustrating the expected motion of the NASA Lucy spacecraft and its instrument pointing platform (IPP) during the encounter with asteroid Dinkinesh. The spacecraft’s terminal tracking system is designed to actively monitor the location of Dinkinesh, enabling the spacecraft and IPP to move autonomously in order to observe the asteroid throughout the encounter. The yellow, blue, and grey arrows indicate the directions of the Sun, Earth, and Dinkinesh, respectively. The red arrow indicates motion of the spacecraft. An animation is available here. Credit: NASA/Goddard/SwRI

Two hours before closest approach, the spacecraft and the rotational platform that holds Lucy’s science instruments (the instrument pointing platform) will be commanded to move into encounter configuration. After this point, the spacecraft’s high-gain antenna will point away from the Earth and the spacecraft will not be able to return data for the remainder of the encounter.

Shortly thereafter, the high-resolution grayscale camera on Lucy, L’LORRI, will begin taking a series of images every 15 minutes. (L’LORRI, short for Lucy’s Long Range Reconnaissance Imager, is supplied by the Johns Hopkins Applied Physics Laboratory.) Dinkinesh has been visible to L’LORRI as a single point of light since early September when the team began using the instrument to assist with spacecraft navigation. The team estimates that at a distance of just under 20,000 miles (30,000 km), Dinkinesh may appear to be a few pixels in size, just barely resolved by the camera.

Additionally, Lucy’s thermal infrared instrument, L’TES, will begin collecting data. L’TES (formally the Lucy Thermal Emission Spectrometer, provided by Arizona State University) is not designed to observe an asteroid as small as Dinkinesh, so the team is interested to see if L’TES is able to detect the asteroid and measure its temperature during the encounter.

An hour before the closest approach, the spacecraft will begin actively tracking Dinkinesh using the onboard terminal tracking system. The spacecraft will use T2Cam (the Terminal Tracking Cameras, provided by Malin Space Science Systems), to repeatedly image the asteroid. In the minutes around closest approach, this system is designed to autonomously reorient the spacecraft and its instrument pointing platform as needed to keep the asteroid centered in the cameras’ field of view. Testing this system is the primary goal of this encounter.

Ten minutes before closest approach, the spacecraft is instructed to begin “closest approach imaging” with the L’LORRI instrument. In these images, taken every 15 seconds at three different exposure times, the asteroid will be several hundred pixels across, allowing the team an unprecedented view of this small main belt asteroid, which is estimated to be less than half a mile (1 km) in diameter.

Lucy will wait until about six minutes before closest approach to begin taking data with its color imager (the Multi-spectral Visible Imaging Camera, MVIC) and infrared spectrometer (Linear Etalon Imaging Spectral Array, LEISA), which together comprise the L’Ralph instrument (provided by NASA’s Goddard Space Flight Center in Greenbelt, Maryland).

About six minutes after the closest approach, L’Ralph will stop taking data, and Lucy will conclude the closest approach observations. By this time, the spacecraft will already be almost 1,700 miles (2,700 km) past the asteroid. Lucy will begin a maneuver referred to as a “pitchback” in which it reorients its solar arrays toward the Sun while the instrument pointing platform continues to autonomously track the asteroid as the spacecraft departs. This maneuver is designed to be carried out slowly to minimize spacecraft vibrations as the spacecraft moves its large solar arrays. L’LORRI will image Dinkinesh throughout this process to monitor spacecraft stability.

Once the spacecraft is over 8,000 miles (13,000 km) from the asteroid, Lucy will stop actively tracking the position of Dinkinesh. From that point on, the team expects the asteroid to remain visible to the spacecraft’s cameras without the need to reposition the spacecraft or instruments.

Two hours after closest approach, the L’TES instrument will be instructed to stop taking data. L’LORRI will continue periodically observing the asteroid for another four days to monitor the light curve of the asteroid.

Once Lucy turns its high-gain antenna back toward Earth, it will be able to resume communications, with an approximately 30-minute light-travel-time delay in each direction. The team expects to receive the first signal from the spacecraft within two hours of closest approach. After assessing the health and safety of the spacecraft, the team will command the spacecraft to begin downlinking the data taken during the encounter. It will take up to a week for all data to be returned to Earth via NASA’s Deep Space Network.

NASA’s Lucy Spacecraft Ready for 1st Asteroid Encounter

NASA’s Lucy spacecraft is on track for its first asteroid encounter on Nov. 1. Lucy’s optical navigation team has confirmed that the latest trajectory correction maneuver on Sept 29 accurately set the spacecraft on course for its flyby of the small main belt asteroid Dinkinesh. The spacecraft is anticipated to pass approximately 265 miles (425 km) from the asteroid at 12:54 p.m. EDT.

On Oct. 28, the team sent the spacecraft what is known as the final knowledge update, a package of data with the most up to date information about the relative positions of the spacecraft and asteroid. This dataset is precise enough to guide the spacecraft for nearly all the half a million miles (800,000 km) that currently separate Lucy and Dinkinesh.

About an hour before the spacecraft’s closest approach, when it’s approximately 10,000 miles (16,000 km) from the asteroid, Lucy will begin actively monitoring the position of Dinkinesh with its terminal tracking system, although due to Dinkinesh’s small size, the system is not expected to “lock-on” to the asteroid until just a few minutes before closest approach. This system will autonomously reorient the spacecraft to keep the small asteroid within the field of view of the science instruments as the spacecraft zooms by at around 10,000 mph (4.5 m/s). This will be the first use of this terminal tracking system, and this flyby was designed to test the system in real spaceflight conditions.

As Lucy approaches Dinkinesh on the morning of Nov. 1, the spacecraft will rotate into a position that enables it to continually track the asteroid. This will move the high-gain antenna away from Earth, and the spacecraft will not be able to communicate again until it has completed the encounter sequence and reoriented itself so that the high-gain antenna is pointing back toward Earth. Imagery and other science and engineering data from the flyby will then be downlinked over the next weeks.